Soclean How To Set Up

User Manual For SoClean CPAP Cleaner

SoClean is the easiest,fastest, nigh effective and safest style to clean your CPAP device. You lot may be enlightened of the importance of keeping a continuous positive airway pressure (CPAP) device make clean. The take chances of getting sick increases if your device has become a dwelling for harmful germs and bacteria.The SoClean is

SoClean is effective  CPAP cleaning auto that is efficient and powerful enough to kill 99.99% of leaner and germs in the CPAP equipment and being very small in size it can fit anywhere.

Getting Started

•Pre-Launder Your CPAP Device.How,When and Why?

The pre-wash is but a hypo-allergic cleaning solution or a dish soap which is fragrance-gratuitous,required to hand wash your CPAP device(mask,hose and reservoir).

Y'all have to mix two capfuls of this pre-launder thoroughly with a gallon of water in lodge to wash your CPAP device and then rinse it with clean water.

You are supposed to use the pre-wash before you apply your SoClean for the starting time time or whenever a new equipment is being introduced to your CPAP device.

It removes any unwanted residues and neutralizes the detergents for whatsoever pre-existing odours.

•How To Install the Injection Fitting?

The procedure of installing the injection fitting is classified into the following categories:

1.Installing The Injection Fitting With Humidifier:

Steps to exist followed in a SEQUENCE:

♦You lot have to first disconnect the hose from your CPAP device.

♦Now,position the injection fitting on the port of your reservoir in such a manner that the smaller hose enters and rests on or most the lesser of your reservoir.

♦Y'all can trim the injection hose,if required, in order to fit it in the reservoir.And you have to ever keep it in mind that there are different ways of hose insertion for unlike reservoirs.

♦If you are willing to keep water in the reservoir,then make sure that the end of the injection hose is always beneath the water level in the reservoir.

♦Now yous can carefully connect the hose of your CPAP device to the end of the injection plumbing equipment.

2.Installing The Injection Plumbing equipment Without Humidifier:

Steps to be followed in a SEQUENCE:

♦Remove the small black hose by pulling it from the injection plumbing equipment if you are not using the humidifier at present.

♦Practice not insert this modest injection hose into the CPAP machine.

♦Now directly adhere the injection plumbing equipment to your CPAP device.

♦Reconnect the end of the injection fitting with the hose of your CPAP device.

♦You can use your CPAP car without disconnecting the injection fitting.

♦Only,it is mandatory to disconnect the plumbing equipment depending on the pattern of your reservoir in order to add together water into it.

Note:Practise Non Hurdle And Follow The Above Steps With Patience.

How To Utilise SoClean To Make clean And Sanitize Your CPAP Auto?

Your CPAP device can be easily cleaned and sanitized.Being ane of the best and globe's first and nigh used CPAP cleaner and sanitizer which uses activated oxygen to kill 99.99% of CPAP mold,bacteria and viruses growing in your mask,reservoir and hose.The use of water or messy chemicals is avoided in order to continue the device completely dry out.

Using the SoClean unit is very easy.You just have to follow the following steps:

♦ Open up the top embrace or the chapeau.

♦Now,carefully put the removable hose slot plug into the open slot.

♦At present just place your mask into the bedroom, shut and tighten the cover so press the push button.

♦Brand sure that the hose attached to the mask rests in the open hose slot.

♦According to the preset time,the SoClean will operate automatically.

♦Subsequently the cycle is completed,you tin can open the lid and have out the mask.

♦Later removing the removable hose slot plug leave information technology inside the sleeping accommodation itself .

Few Of import Points to think:

♦You can insert your mask and hose from either side of the SoClean machine.

♦It won't operate if the mask and hose aren't present within the bedroom.

♦It won't operate if the hose slot plug is improperly seated or missing.

♦Even afterward the cycle is completed you are supposed to get out the mask and hose in the chamber for at least 2 more hours.

You can remove them after the green light shines which indicates the completion of all disinfecting procedure.

Source: https://www.cpapcleanerandsanitizer.com/soclean-user-manual/

Share this post